About Us
About Us
Sales: Miss Nancy Mao
TEL: +86-769-81558215
Mob: +86-15017132235
MSN:
nancy.maomao@hotmail.com
Skype:
nancy.maomao974
E_mail:
nancy@chinashian.com
Sales: Elaine Guan
TEL: +86-769-81558205
Mob: +86-13423130387
MSN:
Elaine86103@163.com
Skype:
elaine.yj
E_mail:
elaine@chinashian.com
FAQ and solutions of pad printing
| There is bubble and sanded aperture on printed graphic | ||
| 1.the pad is too soft | 2.the pad is too falt | 3.the pad is damaged |
| Changing a harder pad | Changing a acuter pad | Changing pad |
| 4.the etched steel board is out of place | 5.the ink is too dense | 6.there is some dusty or stain on surface of the product |
| Remaking steel board | Adding some water | Clean it up by alcohol |
| 7.the using time of ink is too long, leading to go bad | Changing a harder pad | |
| the graphic is blurred after pad printing | ||
| 1.the pad is too soft | 2.the deepth of etching steel board is too deep | 3.there is some dusty on products |
| Changing a harder pad | Changing a suitable deepth steel board | Clean the products up |
| 4.the clamps is non-fastened | 5.the flowing speed of pad is too quick | 6.the ink is too dense or diluted |
| Fastening all the clamps | Adjusting the flowing speed of pad | making the ink fittable |
| the function of ink can’t up to standard requirements | ||
| 1.choosing the wrong type ink | 2.there is some stain on the products | 3.drying and solidify time isn’t enough |
| Choosing stuitable ink according to products | Using acohol to clean the products up | Parching it by hot wind or lower-temperature tunnel |
